58 Gallons RVs Water Tank | Replacement Water Tank for RVs
58 Gallons RVs Water Tank | Replacement Water Tank for RVs


 
INCLUDES:
1- Lower Fitting 3/4" FNPT
1- Upper Fitting 1/2 FNPT

1- 3" HDPE Screw-In/Out Lid

Perfect for RV,s, Mobile Car & Pet Wash Business or Agricultural use, Holds enough water to wash up to 10 Cars. At a Full Capacity, it can weight up to 493 lbs.

DIMENSIONS: 34"L x 34"W x 13"H

WALL THICKNESS:
1/8" - 3/16"

INSTALLATION INSTRUCTIONS:

20 Gallons Portable Water Tanks, is made with a Non-Toxic FDA Accepted High-Density Polyethylene - This Tanks should always be stored out of Direct Sunlight and Protected from Freezing - Prior to installation, tank should be at room temperature for a minimum of six (6) hours - The Tank must be installed on a flat surface Always.

Our Price: $514.94
Sale Price: $399.95
You save $114.99!

Delivery: 6 to 8 Business Days
Payments Credit Cards processed by PayPal

Stock Status:In Stock
Availability:: Usually Ships in 1 to 2 Days
Product Code: RV44W-W


Manway Lid:


Qty:  
Description
 
58 Gallons RVs Water Tank | Replacement Water Tank for RVs

Rectangular Tanks material will be non-toxic FDA accepted high-density polyethylene. TANKS should always be stored out of direct sunlight and protected from freezing. Prior to installation, tanks should be at room temperature for a minimum of six (6) hours.

The tank must be installed on a flat or contour matched surface, be clean and totally supported in all planes with 1/2" - 3/4" marine plywood or equivalent. Install tubing and fittings so that there are no points of stress on the tank. use elbows to prevent partial bending or collapsing of the tubing when a change in direction is required. Plastic tank connections are designed to seal dry.

Compounds such as sealants, pipe dopes, greases, petroleum jellies, glues or adhesives are not to be used. Normally, hand tightening will provide adequate seal. On occasion, a slight tightening with a wrench may be required. To avoid damage to seal fittings, do not apply excessive force. Do not exceed 1/4 turn after hand tightening. Do not install metal fittings in the plastic tank as the materials are not compatible.

Should you desire to test the potable water tank or water system for leaks, fill with water and check visually.

Share your knowledge of this product. Be the first to write a review »